Side-Power SP 200 TC Instruction Manual download pdf (Page 38)

Use the buttonhole cutter to cut the

center, making sure not to cut the

stitches.

Note:

If a marking pin is put in the bar-

tack area it helps to prevent cutting

the bar-tack with the buttonhole

cutter.

Use the buttonhole adjustment •

screw to adjust the balance between

the stitches (rear side).

Adjust by turning with the•

screw

driver of your own.

Don’t turn the screw more than 90°.•

Note:

The original position of buttonhole

adjustment screw may vary

according to the model of machine.

If the stitches are loose on the right

side of the buttonhole, turn slightly

in the “-” direction.

If the stitches are loose on the left

side of the buttonhole, turn slightly

in the “+” direction.

Adjustment of buttonhole balance

Buttonhole

adjustment

screw

Caution

When using the buttonhole cutter to cut the buttonholes, do not hold

the fabric in front of the cutter.

Doing so could cause an injury to your hand.

Buttonhole

cutter

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 54 55

No comments

Side-Power SP 200 TC Instruction Manual Page 38